jnash
11-18-2003, 11:04 PM
Problem: No power, unit will not turn on.
I took the back off and discovered that the main 6 Amp fuse was blown and installed a new one. That didnt fix it as it blew right away.
There is one burnt resistor at location R14069 in between the diodes on the main bottom circuit board in the power supply area and a half burnt resistor R14606 located on th same board closer to the tube.
I have photo's if anyone can help me. I can install new parts if I new what the values of these resistors are.
Does anyone know if this is a common problem. Perhaps a bad diode causing the resister to blow?
What's the scoop?
I took the back off and discovered that the main 6 Amp fuse was blown and installed a new one. That didnt fix it as it blew right away.
There is one burnt resistor at location R14069 in between the diodes on the main bottom circuit board in the power supply area and a half burnt resistor R14606 located on th same board closer to the tube.
I have photo's if anyone can help me. I can install new parts if I new what the values of these resistors are.
Does anyone know if this is a common problem. Perhaps a bad diode causing the resister to blow?
What's the scoop?
